Eurosec CP8L Control Panel. For most domestic and small commercial installations. 32-character LCD remote keypad with fully programmable zone and user descriptors, plus the option of time & date stamp event log, make this an attractive system. CP8L LCD Installation. CP8L Features PD6662 EN.

The difference in the compressibility of the various materials used in the individual sections of the building; b. The unequal loading of the individual parts of a building, for example; as a result of differences in height when constructing sections in parts or in the final stage; and c. Ebcs 10 electrical installation of buildingspdf area.

• Contents Introduction.. 1 Display Status Blanking.2 IMPORTANT USER INFORMATION. • Introduction Welcome to the eurosec control panel. Your installation company will have programmed your system to protect your premises to the highest possible standards. Several user programmable options are available that will be covered later in this manual. Throughout this manual, reference will be made to the Master User Code, the factory set default is 5678. • Display Status Blanking Depending on Control Panel installed, it may be a requirement that the Status (Set or Unset display) of the security system is not displayed.

Set or Unset Status will only be displayed for ten seconds when the system is Set or Unset. The bottom line of the display will then be blanked off. • Full Setting the System. Two methods are available for Full Set. After checking the premises are secure: Enter a valid User Code followed. * If enabled by the installation engineer.

The exit tone will now sound. Exit the premises via an authorised exit route. • Pre Exit Check.

At the start of the setting procedure, a fault Exit Now!.. Tone will sound if any non exit routes are Zone 3 open. The display will show, for example:- If the fault clears within 20 seconds then the exit tone will begin, if not, the fault tone will continue until a valid User code is entered. • Part Setting the System (using Part 2 or 3). Two other Part Sets may be available for your system.

Part 2 is a second set of zones that may be omitted and Part 3 will combine Part 1 and Part 2. To use Part 2 or 3. Enter a valid User Code followed by 2 or 3. • Unsetting the System. Enter the premises via an authorised Entry Point. The entry tone will sound. Proceed to the keypad and enter a valid User Code.

Display After an Alarm. If an alarm occurs when the system is set, the cause of the alarm will be displayed for 10 seconds after you unset the system. • Resetting After an Alarm After an alarm the system needs to be reset. Your installation company will have programmed the reset modes for your system so that it complies with your insurance company and legislation requirements. Your installation company will have informed you as to the type of reset that your system is set for. • If a Master Code Reset has been programmed by the engineer, a higher level of code will be required.